Hello! Laser Cutter FAQ is a community-based Question and Answer site. Sign up to post a question or answer, to leave a comment, or to up-vote good answers!

Is it normal for power to vary across the laser bed?

0 votes
asked Oct 23, 2017 by jimmit (3,660 points)
The laser seems to cut and engrave well in some locations but have less power in other spots. Is this normal?

1 Answer

0 votes
answered Oct 23, 2017 by jimmit (3,660 points)
No, the power output should be consistent across the work area.  More than likely this is a symptom of poor mirror alignment or not having the bed level.  This causes the laser to not be properly focused everywhere within the work area.
Welcome to Laser Cutter FAQ, where you can ask questions and receive answers from other members of the community about Laser Cutting and Engraving.
...