Hello! Laser Cutter FAQ is a community-based Question and Answer site. Sign up to post a question or answer, to leave a comment, or to up-vote good answers!
0 votes
by (5.1k points)
The laser seems to cut and engrave well in some locations but have less power in other spots. Is this normal?
 

1 Answer

0 votes
by (5.1k points)
No, the power output should be consistent across the work area.  More than likely this is a symptom of poor mirror alignment or not having the bed level.  This causes the laser to not be properly focused everywhere within the work area.
Welcome to Laser Cutter FAQ, where you can ask questions and receive answers from other members of the community about Laser Cutting and Engraving.

Categories

Related questions

0 votes
1 answer
0 votes
1 answer
0 votes
1 answer
asked Jul 27, 2017 by jimmit (5.1k points)
As an Amazon Associate LaserCutterFAQ earns from qualifying purchases. LaserCutterFAQ also utlizes other programs to earn a commission when you follow our links. There is no added cost to you.
...